Series 1060
9
Framing Dimensions
Inches
MM
Top - to standoffs
0”
0
Sides-to standoffs
0”
0
Adjacent Side Wall
12”
300
Floor (from opening)
0”
300
Front (from opening)
12”
300
Ceiling (from opening)
36”
900
Paints:
When painting around any fireplace it is rec-
ommended by the Master Painters and Deco-
rators Association that a quality Alkyd sealer
is applied before applying of latex paints. This
prevents leaching of water from evaporation
thus causing discoloration.
Figure 5
Table 3
Combustion Air Requirements
As a rule it requires 800-1000CFM of
fresh air to burn 10,000 Btu’s of nat-
ural/propane gas.
Note:
During the quote process we will
require the altitude of the install so
that the unit will arrive set up for your
installation.
However it is the responsibility of the
installer to check setup in his area is
correct.
Some areas for instance will down
rate the calorific value of the gas
supply to allow for altitude.
Venting
Certified ‘B’ Vent or flex pipe may be
used. See table #** for clearances.
All sealed models use 10” pipe.
Figure 5
Figure 6
Summary of Contents for 1060 Series
