Nibart 1060 Series, User'S Installation, Operation And Maintenance Manual

Page: 30 / 44

Series 1060
30
REMOTE CONTROL SETUP AND OPERATION (SKYTECH)
Programming:
Countdown Timer -
enables the operator to program fireplace for automatic shutoff, up to a max of 3hrs (10min in-
crement)
To enter timer mode, press and release button, (#17 will start blinking)
to adjust the running time, in 10-min increments. Press and release to activate
timer.
Thermostat Mode -
fireplace will automatically modulate heat output to programmed temperature
Press button to cycle the hand held remote to the Thermostat Mode, this will activate the smaller
SET window(#11) . The factory setting will be 45 ° F. Use the at any time to adjust the temp you would like maintained.
Pressing the button will cancel the THERMO function and turn the fireplace off.
The fireplace will modulate the flame up and down depending on how far from the set temperature the remote senses it to be.
The fireplace incorporates a 2
° swing on the temperature readings. When set for 70 ° F the fireplace will modulate down and shut
off at 72
°
. The flame at set temperature (Level 2 flame) will adjust up 1 level per degree to a maximum of 5
°
. At 5
°
below set
Program Mode - (
2) Weekday and Weekend programs
Press and hold for 5 seconds to activate programming mode will blink
Turn fireplace ON
to adjust time . to advance to next function Turn
fireplace OFF
Repeat for fireplace ON and fireplace OFF. to advance to Weekend schedule
Turn fireplace ON
to adjust time. to advance to next function
Turn fireplace OFF
Re- peat for fire- place ON and fireplace OFF. to finish.
Press to activate this function when required.