Nibart 1060 Series, User'S Installation, Operation And Maintenance Manual

Page: 33 / 44

Series 1060
33
TROUBLESHOOTING (SKYTECH SYSTEM)
Module Error Codes
The Skytech Control Module has built in error code notification. Identifying the audible sequence from the
module will enable a speedy diagnosis.
Ignition Safety - (1) beep every (1) sec
Reason:

pilot not lit after 60 seconds
Communication Safety - (1) beep every (4) sec
Reason:

Remote and Module not communicating
properly
Sensor Safety - (4) beeps every (1) second
Reason:

Pilot sensor detecting existing flame when
ignition initiated

Pilot sensor on main module shorted to
ground
Thermal Safety - (1) beep every (2) sec
Reason:

Module internal temp exceeds 170 °
Things to check

Ensure gas supply is ON

2-pin wire plug for pilot is secured into the “pilot” connection on
gas valve

Check Igniter lead is secured to “I” terminal on module (clicking
from box may be heard if loose)

Check Flame Sensor lead is secure to “S” terminal on module
(pilot will light but no main burner, pilot goes out after 60 secs)
Error Code

Main control module getting too much heat. Shield or move to
new location

Keep area in front of lower grills clear of clutter to accommodate
air flow

Cool module’s temperature below 160 ° F then cycle remote to
ON to clear code

Ensure remote is within 20ft of module

Ensure remote is not placed on top or inside of a metal enclo-
sure. This can interfere with signal

Confirm batteries in remote are charged

Remote will send a safety signal every 15min, if module does not
receive the signal, it begins a 2hr shut off countdown.

This function is active in both MANUAL and THERMO modes

Check for active pilot flame when gas valve is turned off (is yes
replace valve)

Ensure no debris is touching the sensor

Check for frayed or cut wires / confirm ground

Check for cracked porcelain insulators

Replace pilot assembly

Replace module
To clear the Hand Held remote error codes cycle on remote to OFF then to ON to attempt fireplace re-start.
Sensor Safety Override - temporarily override Module Error Shutdown to ignite pilot (Remotes with (-2) model code only)
Press and to activate pilot light ignition sequence. Remote must be in OFF mode to activate this
function. The Cont Pilot will flash (#5) on the LCD. Release the buttons to deactivate.