background image

 

 

 

 

FEDERAL COMMUNICATIONS COMMISSION 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions:(1) this device may not cause harmful interference, and (2) this device must 
accept any interference received, including interference that may cause undesired 
operation. 
 

NOTE 

This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection. This equipment generates, uses and can radiated radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will 
not occur in a particular installation If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the equipment off and on, 
the user is encouraged to try to correct the interference by one or more of the following 
measures: 
 
-Reorient or relocate the receiving antenna. 
-Increase the separation between the equipment and receiver. 
-Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 
-Consult the dealer or an experienced radio/TV technician for help. 
 
Changes or modifications not expressly approved by the party responsible for compliance 
could void the user‘s authority to operate the equipment. 
 

 

 

 

 

 

 

 

 

 

 

 

Summary of Contents for GRA 02








Reviews: