Nexxt Solutions - NexxtGate Wireless Access Point
39
Note:
Changes will take effect only after the device reboots.
4.8 Wireless settings
Go to
Wireless Settings
in order to enable the configuration of some advanced settings for the
device in the following screen, as shown in Figure 4-26.
!
•
•
•
•
•
•
•
•
•
Enable WMM
- WMM function guarantees that packets with high- priority messages to be
transmitted preferentially. It is strongly recommended to have this feature enabled.
Enable AP Isolation
- This function can isolate wireless stations on your network from each
other. Wireless devices will not be able to communicate with each other through the WLAN.
This option is available only on Access Point mode.
Disable short preamble
- Check this box to disable the short preamble and use the long
preamble only.. It is recommended not to modify these settings.
RTS threshold
- Here you can specify the RTS/CTS (Request to Send/Clear to send)
threshold, which is the packet maximum size defining whether RTS/CTS frames should
be sent.
Fragmentation Threshold
- The maximum packet size used for fragmentation.
Beacon Interval
- The time interval between two successive beacons.
Power
- The transmit power of the access point. The checkbox determines whether the
transmit power conforms to regulatory levels or not. Un-checking the Obey Regulatory
Power option may cause interference to other devices and also violate applicable laws in
some areas.
Antenna Settings
- The polarization of an antenna.
Signal LED Thresholds
- The RSSI thresholds of the signal LEDs.
Figure 4-26 Wireless settings
