Nexxt Solutions - NexxtGate Wireless Access Point
21
•
Note:
1.
2.
3.
1.
4.5.2 WAN
Go to
Network
>
WAN
to enable the configuration IP parameters of the WAN port on this page.
First, please choose the WAN Connection Type (Dynamic IP/Static IP/PPPoE) for the Internet.
The default type is Dynamic IP. If you are not given any login parameters (fixed IP Address, logging
ID, etc), please select Dynamic IP. If you are given a fixed IP (static IP), please select Static IP. If you
are given a user name and a password, please select the type of your ISP provided (PPPoE). If you
are not sure which connection type you are currently using, please contact your ISP to obtain the
correct information.
This page displays the WAN IP parameters assigned dynamically by your ISP, including IP address,
Subnet Mask, Default Gateway, etc. Click
Renew
to obtain new IP parameters from your ISP.
Click the
Release
button to release the assigned IP parameters.
If you change the IP Address of the LAN, you must use the new IP Address to login to
the Router.
If the new LAN IP Address you set is not in the same subnet, the IP Address pool of
the DHCP server will not take effect until they are re-configured.
If the new LAN IP Address you set is not in the same subnet, the Virtual Server and
DMZ Host will change accordingly at the same time.
If you choose Dynamic IP, the router will automatically get IP parameters from your ISP.
Please refer to Figure 4-5 below.
MTU Size
- The normal MTU (Maximum Transmission Unit) value for most ethernet networks is
1500 bytes. For some ISPs you need to reduce the MTU. But this is rarely required, and should
not be done unless you are sure it is necessary for your ISP connection.
Figure 4-5 WAN – Dynamic IP
