Nexus Multi Control, Installation And Operation Manual

Page: 12 / 83

11
2.1 Location of the Server
The Server must be mounted on a dry, flat and vertical surface
below deck , at least 500 mm (20") from radio receiving
equipment.
Locate the Server in the centre of the boat and close to the
electrical panel if possible.
2.2 Installing the Server
Remove the Server cover from the baseplate by removing the two
screws. Drill the 4 screw holes using a 2.8 mm (0.11") drill. Mount
the Server using the 4 mounting screws.
Apply silicon paste on the screw terminal. Connect the 8 m Nexus
Network cable labelled number 5 and supplied with cable
protectors to the Server on pins 5, 6, 7, and 8. Match the colour
codes for each wire.
Note: If the cable must be cut, it is recommended it is cut at the
un-marked cable end, since a marked cable is easier to identify.
When all connections are made, use the cable straps as required.
Mount the Server cover using the 2 mounting screws.
Your Server installation is done!
INSTALLATION