5/8 - Safety instructions and usage guide for the automatic pool cover
5
This document is the property of AS POOL - of the NextPool group and cannot be reproduced or communicated without our authorisation.
1
power off the box.
2
Block the rotation of the axis while keeping the
blades rolled around it.
3
For the OPEN, remove the cover on the motor
side (remove the OPEN PVC cap, loosen the
composite cover from the OPEN Solar). Disconnect
wires 1, 2, 3, and 4 of the motor cable in order to
slide it completely towards the axis and remove the
unlocking ring.
4
For the BANC, remove the top cover and unscrew
the butterfl y screw from the cover inside the BANC
Solar. Disconnect wires 1, 2, 3, and 4 of the motor
cable in order to slide it completely towards the axis
and remove the unlocking ring.
5
For the IMM'Box: remove the key between the
shaft and the motor, or remove the motor.
6
For the IMM'Ax: in the motor connection box
located close to the pool, disconnect the end of run
stop wires and the power wires from the motor cable
in order to slide the motor cable completely towards
the axis. Remove the pin blocker to access and lift
the unlocking pin.
7
Manually accompany the unrolling of the cover,
making sure that the motor cable does not get
entangled.
8
Lock the safety mechanisms.
When commissioning the roller, a new adjustment of
the motor end of run stops will be needed.
4. Appendix maintenance
advice
In the event of a malfunction or a repair preventing
the closure and the securing of the pool, take all
necessary measures to prevent the access to the
pool of children of less than 5 years old.
• AS POOL (ABRIBLUE) only distributes its technical
products via a network of pool professionals which
carries out the installation and follow-up depending
on the specifi cities of the pool. AS POOL (ABRIBLUE)
does not communicate directly with the pool owners.
Have Servicing of the automatic cover carried out by
a professional trained to this effect (we recommend
your installer of whom the details are on the cover of
this manual), they will be able to contact our technical
assistance department. All spare parts must be original
spare parts in order to maintain our guarantee and the
cover’s compliance with the standard.
• Carry out a complete revision of the cover once per
year.
• Each time it is commissioned, the cover should
be inspected to identify deteriorations that may
compromise its correct operation. A professional will
diagnose whether some blades need to be replaced.
• Check that the maintenance advice is applied and that
the user carries out the checks regularly. Otherwise go
over them item by item.
• Check that the coupling nuts are tightened, that the
stop ring and all the screws are present on the axis.
• Check that the electric connections are tight and
operate correctly. Make sure there is no humidity or
oxidation on the cover's electric contacts (terminals in
the box, box connections, contacts and key switch).
• Check the condition and the ageing of the locking
mechanisms and the elastics used to maintain the PVC
blades. Check that the straps are tight on the axis.
• Check the correct operation of the fi ltering system, the
overfl ow and the water level regulator.
• Carry out several rolling and unrolling tests to make
sure the cover is operational and especially to check
that the end of run stops are correctly placed.
• When the system does not respond, your installer
can secure the pool by uncoupling the cover roller
and manually unrolling the cover onto the pool before
locking the safety mechanisms on the pool cover. In
this situation the pool cannot be used until the cover is
repaired.
• Handling the uncoupling of the roller mechanism, to be
read thoroughly before operation, with the installation
instructions.
