76
No picture. (Blue or black TV screen
or all snow picture)
TV or RG2C may not be activated.
Refer to
“Getting Started” on page 15
.
Video signal may not be reaching the
TV.
Make sure all cables are connected properly and that your
TV is tuned to the correct RF channel (for example 6,7, or
13) for the TV you are using (TV-1, TV-2, or TV-3). If the
baseband video output on the RG2C is connected to the
VIDEO IN input on the TV, make sure the TV is set to the
correct video input.
VCR may be set incorrectly.
Check to see how the VCR is connected to the RG2C. If
the baseband video output on the RG2C is connected to
the VCR, the VCR must be ON and programmed to LINE
IN or VIDEO IN.
Make sure VCR/TV is set to TV.
Make sure the TV is set to the correct TV channel or video
input.
No picture.
Your RG2C may have recently
received a software download.
Sometimes after a download the
system fails to restart. You may need
to manually restart your RG2C.
To restart your RG2C, press and hold down the power
button on the front panel for 5 seconds.
Picture is distorted.
Coaxial cable is disconnected or
loose.
Reconnect or tighten the cable.
All-snow picture on all TV channels. VCR is on at this location and TV is
on wrong channel.
Call your NSP to reset your RF channel.
TV is on wrong channel for Source.
Call your NSP to reset your RF channel.
Problem
Possible Cause
Try This
