61
Add an Ethernet hub to your RG2C system by following the steps below. Then pro-
ceed to Task 3.
Note:
You do not need to remove the RG2C power cord or disconnect the network
cable from the RG2C while following these steps.
1.
Disconnect the Ethernet workstation cable from the 10/100BaseT connector on
the rear panel of the RG2C.
2.
Disconnect the other end of the Ethernet workstation cable from the workstation.
You may or may not be able to reuse this cable to connect the RG2C to the Ether-
net hub, depending on whether a crossover or straight-through connection is
needed. You should be able to reuse this cable to connect the Ethernet hub to an
Ethernet workstation.
3.
Install the hub and the Ethernet workstations, as instructed in the manufacturer’s
instructions.
