17
Phillips Head Screwdriver (+)
6mm Nut Driver
Steps
：
1.
Remove the main tube burners by removing the screw securing the burners near the back wall of the
firebox and the screws near the front of the firebox that secure the igniter brackets to the burners. Gently lift
the question mark burners up and out.
2. Locate and remove the LP orifice at the end of each valve with an nut driver. The main burner NG orifices
are located behind the LP orifices, so no additional orifices need to be installed.
CAUTION
: The NG orifice is
easily loosed or even removed together with the LP orifice when the LP orifice is being unscrewed. Make sure
the NG orifices are securely installed on the main burner valves after the LP orifices are removed.
3. Restore the main burners. CAUTION: Make sure the value with orifice is inserted into the burner venturi.
Restore the igniter brackets; adjust the distance between the burner and the corresponding igniter for proper
ignition.
Rear Burner Conversion
Tools required:
Phillips Head Screwdriver (+)
6mm wrench
Figure 2240
CSA International
Project 2056659
18 of 25
