18
Steps
：
1. Remove the three screws securing the wind baffle and six screws securing rear baffle from inside the grill.
Remove the Rear Baffle from the back of the grill.
2.
Unscrew the LP orifice with two wrenches from the connector—one wrench to hold the
orifice connector in place and the other wrench to remove the LP orifice. Take extra pre-cautions to make sure
the corrugated tube does not twist. Install the NG orifice and screw into place
.
3. Replace rear baffle & wind baffle and screw back into original position.
CARE AND MAINTENANCE
Stainless Steel
There are many stainless steel cleaners available. Always use the mildest cleaning process first, scrubbing in
the direction of the grain. Do not use steel wool as it will scratch the surface. To touch up noticeable scratches
in the stainless steel, sand very lightly with dry 100 grit sand paper in the direction of the grain.
Grease specks can gather and bake onto the surfaces of the stainless steel, giving the appearance of rust. For
removal, use an abrasive pad with a stainless steel cleaner.
Cooking Grates
The easiest way to clean the grill is immediately after cooking is completed and the flames have been turned
off.
Wear a barbeque mitt to protect your hand from heat and steam.
Scrub the hot cooking grates by dipping a bristled barbecue brush in tap water. Cleaning will be more difficult if
the grill is allowed to cool.
Adjustable wrench
Figure 2240
CSA International
Project 2056659
19 of 25
