NewTek NDI HX PTZ3, Operating Instructions Manual

Page: 21 / 66

Page | 21
Section 2 REMOTE CONTROL & OSD
Some of the more exotic settings and options available on your NDI|HX-PTZ3 are supported
by means of the onscreen display, and accessed via the included remote control. This section
first describes the features of the latter, then provides a full list of options and settings in the
‘OSD’.
2.1
REMOTE CONTROL
The following table identifies the various controls and buttons on your NDI|HX-PTZ3 remote control.
Power
Under normal working mode, short press POWER
key, to enter standby mode. Press it again, the
camera will do self-configuration, then go back to
HOME position. It will go to preset position if power
on model has been set before.
FREEZE (Not Supported in OSD)
Short press FREEZE key to freeze/ unfreeze the
image.
IRT (IR Transfer/IR Pass)
Open/close the IR pass function. Press the IRT key
the camera will receive and Pass the IR remote
control signal to the codec/terminal (via VISCA IN
port).
SET1-SET4 Address Setting
Long press for 3 seconds until the key light ON
CAM1-CAM4 (Camera Selecting)
Short press to select the relative camera.
NUMBER KEY (1-9)
Set preset: long press (3 seconds) the number key to
set preset. Run preset: Short press the number key
to run preset.
CLR PRE (CLEAR PRESET)
CLR PRE+ number key: to clear the relative preset.
Long press to clear all presets.