Unit Menu
Reference Manual for EL470 IP Satellite Modem
Command
SyRef10MTuning
10 MHz operator
frequency adjust
10 MHz oper. adjust
units
units
0
-50 .. 50
Command
SyRef10MCalib
10 MHz ref. factory
default
10 MHz factory defau
Location
/Unit/Control
Only applicable for modems equipped with a 10 MHz Reference Board.
Description
Readout of the internal 10MHz reference frequency calibration factory
default. This is the factory-calibrated tuning value for the internal 10 MHz
reference oscillator. This value is determined during factory calibration and
is hard-coded into the reference board. It can not be changed by the
operator.
This value will be used when
SyRef10MCtrl
is set to
by factory
.
Otherwise when set to
by operator
, the value entered in
SyRef10MTuning
will be used to adjust the 10 MHz internal reference
frequency.
RMCP
Command
RFc
Access
Normal user : no
access
Expert user : R
SNMP
Table
ntcDevsMod01SystemEntry
Command
ntcDevsMod01SyRef10MCalib
OID
1.3.6.1.4.1.5835.3.1.1.1.42.0.1
Values
GUI Unit
units
Cmd Unit
Factory Default (CU)
units
0
Expert Range (CU)
-50 .. 50
Command
SyRef10MCtrl
10 MHz reference
calibration control
10 MHz cal. control
Location
/Unit/Control
Only applicable for modems equipped with a 10 MHz Reference Board.
Description
Configuration of the internal 10MHz reference calibration control.
The internal 10MHz reference frequency can be controlled by either the
factory-calibrated value or the operator-controlled tuning value.
RMCP
Command
RFC
Access
Normal user : no access
Expert user : RW
SNMP
Table
ntcDevsMod01SystemEntry
Command
ntcDevsMod01SyRef10MCtrl
OID
1.3.6.1.4.1.5835.3.1.1.1.43.0.1
Values
Factory Default
factory
Enumeration
Value
By factory
By operator
0
1
version 3.1
25
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
