© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
86
ELECTRONICS
Source(s): L-Panel 2A-4.3” User Guide RevD02 (6/27/2019)
Product(s): KIB Tank Monitor System 4.3” Display (Model: L-Panel-4.3
Inches, Newmar Part Number: 137131) and KIB Tank Monitor System
Control Board (Model: TMSC-100, Newmar Part Number: 137127)
Top Off Button
This button triggers the auto fill routine to start, regardless
of the fresh water tank level. If the water level is greater
than 95%, then the auto fill will only activate for the extra
30 seconds.
Note: The purpose of this button is to top off the fresh
water tank before disconnecting from a water supply
when the tank level is above 50%. The top off button LED
also represents when the fill solenoid is activated.
Water Pump Button
This button activates and deactivates the RV’s fresh water
pump.
Tank Heat Indicator
If the tank is equipped with a heating pad, there will be
a tank indicator below the tank bar graph. When tank
heater is active, the indicator will turn orange. When the
tank heater is inactive, it is grey.
Tank Heat Button
If equipped, this button activates and deactivates the tank
heaters if the following conditions are met (per tank).
•
Tank is equipped with a heating pad.
•
Tank is at least 5% full.
•
The activation delay of 1 minute has passed.
Note: The TMSC-100 is not monitoring any temperatures;
it simply activates or deactivate the heat pads.
•
When the auto fill button is activated and the fresh
tank level is below 50% for more than 15 seconds, the
water fill solenoid valve becomes energized.
•
When 90% is reached, a safety timer of 2 minutes is
activated, which will stop the current fill. The timer is
bypassed at 95%.
•
When 95% is reached, there is an extra activation
time of 30 seconds for the water fill solenoid before
deactivating.
Note: The water fill solenoid has a max activation time
of 15 minutes. When the water level crosses 50%, the
timer will be start again for another 15 minutes. If the max
activation time is ever reached, the auto fill button will
deactivate.
Battery Level Display
Auto Fill Button
There are two batteries being displayed: house and
chassis. The chassis battery bank supplies power to
everything a customer requires to drive the unit. The
house battery bank is necessary to operate everything
a customer may require in order to live in the unit.
The TMSC-100 does not control battery charging, only
monitors voltage.
If equipped, this button activates and deactivates the
auto fill setting, which is retained following a battery
disconnect.
•
When the battery indicator is green, the voltage is
between 9.5V to 14.5V.
•
When the battery indicator displays an orange bar,
the voltage is less than 9.5V.
DEFINITION OF AUTO FILL
Operation
The KIB multiplex switch panel controls the lights,
water pump, floor heat, and fans when wired to the
corresponding switch label. The switch panels will vary
by coach model and floorplan.
Press the switch labeled with the circuit you wish to
operate. The green LED indicator will illuminate on the
KIB switch panel when the circuit is activated. Pressing
the switch again will turn the circuit off and the indicator
will change to blue when it is turned off.
KIB Multiplex Switch Panel Operation
This article provides brief operating instructions for KIB backlit multiplex switches.
KIB Multiplex Systems
CEILING
CEILING
KIT/LRM
KIT/LRM
DRESSER
DRESSER
A
ACCENT
CCENT
HI/
HI/L
LO
OW
W
Summary of Contents for Kountry Star 2022
Page 1: ...SM 2022...
