© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
169
PLUMBING
Source(s): Dometic 8700 Series MasterFlush Macerator Toilet Operation Manual
Product(s): This source is associated with more than one product. Refer to Newgle
for more information about the product(s) offered for your coach’s model year.
Dometic macerator toilets use a Dometic control module
and a wall-mounted flush switch, which can be located in
a basement compartment, cabinet, or on the floor (behind
the toilet). The module will be located no more than 6 feet
from the toilet. The module has power, ground, two tank
level warning wires, and a communication cable.
Adding Water To The Toilet Bowl
Press the “Add Water” switch until the desired water level
is achieved. The water flow will shut off automatically if
switch is pressed too long to avoid overflow. More water is
usually added only when flushing solids.
Flushing The Toilet
Press “Flush” switch, then release it. This activates a
powerful macerator pump that siphons water and waste
from the bowl, macerates, and propels the effluent
through the discharge line to the holding tank.
Changing Flush Modes
Dometic 8700 series MasterFlush toilets offer two flush
settings to help manage water consumption:
1. Normal Flush: Uses 0.85 gallons per flush and adds
water to bowl after ever flush.
2. Dry Bowl Flush: Uses 0.45 gallons per flush and does
not add water to bowl after flush.
To change from Normal to Dry Bowl flush setting, press
the “Flush” switch for about five seconds. When the
“Power On” light begins flashing, release “Flush” switch.
The flush mode has been changed to Dry Bowl setting.
Change the mode to Normal flush by following the same
procedure.
Indicator Lights
•
“Power On” Indicator: On the Dometic flush switch
panel, as steady green “Power On” light indicates
when electrical power to the toilet is activated. A
momentary flashing green light indicates when flush
mode is changing.
•
Tank Level Indicator: The flush switch panel includes
a bi-color “3/4 Full” (amber) and “Full” (red) Tank
Level light to indicate when the holding tank is
approximately 75% or 100% full and should be
pumped out. When the red light is illuminated,
electrical power to the toilet automatically shuts off to
prevent overfill of the holding tank.
Dometic MasterFlush Toilet Electronic Flush Switch
Panel Operation (Models: VFS, VFP, VFSHW, DFS,
DFP, DFSHW)
This article provides basic operational instructions for a Dometic MasterFlush Toilet Electric Switch Panel (VFS, VFP, VFSHW,
DFS, DFP, DFSHW).
Operating The Switches (8000
and 9000 Series Toilets)
For electronic MasterFlush toilets, these wall-mounted
flush switches and status panels feature streamlined
styling while delivering user-friendly push-button
operation. System status lights monitor vacuum level and
indicate when the toilet is properly energized for the next
flush.
TOILET SYSTEM STARTUP:
•
Turn ON electrical power and water supply to the
toilet.
•
Flush the toilet by pressing the Flush button or
waving a hand over the motion sensor(DFSHW only).
Allow the flush cycle to complete.
•
Toss several sheets of toilet tissue into the bowl and
flush the toilet again. The bowl should be completely
clear.
•
9000 Series:
If the bowl is not completely clear after
flushing, adjust the rim and jet water flow timing on
the toilet control module to a higher setting. Repeat
the flush test after each adjustment.
Summary of Contents for Kountry Star 2022
Page 1: ...SM 2022...
