© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
156
PLUMBING
Oasis Operation via KIB LCD
Touchscreen
Set the thermostat zones on “Furnace” mode, and adjust
each interior zone temperature setting as desired. The
separate Oasis System switches must be turned on, and
the water temperature in the Oasis System must be up to
temperature for the basement heat to work.
This article provides a brief overview of the Holding Tank Heat Pad Switches and Indicator Lights. Coaches produced and
equipped (after June 2015) with optional holding tank heating pads are GFCI-protected and incorporate an indicator light to
the switch panel to signify that 120 volt electricity is being supplied to the heating pads.
If the indicator switch does not illuminate when you turn
it on, check the GFCI outlet located in the basement
compartment (the location will vary based on coach
floorplan and tank placement).
The heat pad switches may be incorporated in the
monitor panel in 2018 (and newer) coaches equipped with
the KIB tank monitoring system.
If your coach is equipped with tank heat mats and the
switch is activated, the tank heat icon will appear under
the grey and black tanks. The tank level must be at least
five percent for the control panel to send power to the
tank heater and has a one minute delay before activation.
If the tank is equipped with a heating pad, there will be
a tank indicator below the tank bar graph. When the
tank heater is active, the indicator will turn orange. When
inactive, the indicator will turn grey.
Holding Tank Heat Pad Switches and Indicator Lights
The TMSC-100 is not monitoring any temperatures;
this simply activates or deactivates the heat pads.
IMPORTANT
!
Oasis Hydronic Heating Basement Heat Convector(s)
Coaches with Oasis Hydronic Heating will have a heat exchanger, dual fans, and a designated thermostat. The basement
heat is activated by a separate fixed thermostat in the basement area when the compartment temperature falls below
approximately 40 degrees Fahrenheit. If this happens, the hot antifreeze solution in the Oasis system will circulate, and the
blower will turn on to supply heat in the basement/water compartment area. The Oasis system must be turned on and the
fluid must be above the low temperature cutout for heat output.
Water Compartment Heating: Oasis Operation via
KIB LCD Touchscreen
Oasis Basement Heat Exchanger
Oasis Dual Fan on Basement Heat Exchanger
Oasis Bi-Metallic Thermostat
Summary of Contents for Kountry Star 2022
Page 1: ...SM 2022...
