4VAL Operating & Maintenance Manual Version 1.1 © Newman Labelling Systems Ltd Page 44 of 56
use adjusting screw ‘F’ to pivot the arm about bolt ‘B’ to obtain the required
adjustment. The stripper arm, as is the conveyor surface, is levelled using a spirit
level. Re-tighten the bolts after this setting is complete.
•
The front edge of the stripper plate is set at 90 degrees to the conveyor by
slackening the stripper plate-securing bolt and pivoting the plate the required
amount by hand. After making the adjustment, re-tighten the securing bolt.
Run the machine to check that the label web tracks correctly. If necessary,
make a further adjustment
.
