Newland NLS-NVH200, User Manual

Page: 42 / 253

28
Delay Settings
Reread Delay (Same Barcode)

Enable
：
Do not allow the scanner to re ‐ read same barcode before the timeout between decodes (same
barcode) expires.

Disable
：
Allow the scanner to re ‐ read same barcode.

Default
：
Disable the reread delay.
Enable reread delay
** Disable reread delay
Reread Delay Timeout (Same Barcode)
The following parameter sets the timeout between decodes for same barcode. It is programmable in 1ms
increments from 1ms to 3,600,000ms. The default setting is 15,000ms.
Reread delay timeout(same barcode)
Set up reread delay timeout for the same barcode as 1000ms, you can refer to the
following sequence.
1. Scan the “Enter Setup” barcode.
2. Scan the “reread delay timeout” barcode.
3. Scan the numeric barcodes “1”, “0”, “0” and “0” from the “Digit Barcodes” section in
Appendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Exit Setup barcode.