Part No. 803171 Issued 3-28-13 Rev 011515
3
5. Press QCD towards the dispensing
spout until it is flush with the collar
of the QCD.
6. The BIB should lie horizontally
•
Avoid loops in the product line
•
Use the minimum amount of
product line required.
•
Check for air bubbles in the product
line to trouble shoot for priming.
PRIME SYSTEM
7. After the BIB has been connected to
the QCD valve dispense ap-
proximately 12 ounces of product.
8. Dispense another 8 ounces of prod-
uct and sample for taste. If an
adjustment is necessary, refer to taste
calibration section page #7
NOTE: Be sure there are no air bub-
bles in the product line.
Cleaning Instructions
To clean and flush lines before connecting
BIB product to unit or when changing
product. Flush should be performed at least
once a week.
Note:
Cleaning requires the use of a
cleaning/flush adapter. An adapter may be
purchased from Newco Enterprises, Inc.
#320282 for QCD cleaning/flush adapter.
#120508 for Scholle cleaning/flush
adapter.
A cleaning adapter can be made by taking
an empty BIB bag and cutting away as
much of the empty bag as possible. Wash
the remaining connector and further trim
off any remaining bag pieces if desired.
This is now your cleaning adapter. It will
allow the check valve in the connector to
stay open during the cleaning process.
Cleaning adapters may be saved for later
use.
1.
Connect clean/flush adapter to QCD or
Scholle connector.
2.
Place connector with adapter in
container of hot water.
3.
Lock or hold faucet handle down until
clear water runs from faucet.
4.
Remove adapter from connector.
5.
Attach connector to new BIB.
Flush Position
