New Leader AGCO NL5258G5, Operator'S Manual

Page: 35 / 142

- 35 -
NL5258G5/NL5300G5
www.New-Leader.com
(800) 363-1771 314732-AA-B
Header Insert Installation
Parts Needed:
Description Qty
Divider - Lower Weldment 1
Bolt - Carriage 3/8-16NC x 1 SS 4
Washer - Flat 3/8 SS 8
Nut - Lock 3/8-16NC SS 4
Cover - Weldment Rear 1
Pin - Hair 2
1. Remove hardware from rear two chain shield holes
on each side of M
ULT
A
PPLIER
and set aside.
2. Figure 1 - Install M
ULT
A
PPLIER
Hillside Divider
Support (A) and fasten to M
ULT
A
PPLIER
by reinstalling
chain shield hardware. Slip M
ULT
A
PPLIER
Hillside
Divider (B) up into place and loosely install supplied
hardware.
B
A
B
A
Figure 1 - M
ULT
A
PPLIER
Hillside Divider
3. Verify that Divider is square by measuring from
each side of the Divider to the M
ULT
A
PPLIER
chain
shields. Measurements must be equal.
4. Tighten all hardware to recommended torque.
5. Figure 2 - Install Conveyor Cover (C) and secure
with hair pins D) on each side.
C
D
C
D
Figure 2
HILLSIDE DIVIDER & CONVEYOR COVER
NOTICE!
Highway Equipment Company will not be liable for misapplied material due to an improperly
adjusted divider, spreader or both.