4 Cycle time counts down from 3 to 0 then console start, meanwhile buzzer beeps
once per second and
READY
flashes once per second, counting displays ‘00/
XX’(Figure 31).
5 Cycle time counts down from the pre-set total time and
WORK
flashes once per
second. Then
TOTAL TIME, DISTANCE, CALORIES, WATTS, SPEED
&
RPM
start
calculating, counting displays ‘01 XX’(Figure 32).
6 Cycle time counts down from and
REST
flashes once per second along with
buzzer beeps(Figure 33), meanwhile
READY
will flash in the last 3sec(Figure 34).
8 In
WORK
mode, the buzzer beeps for 1sec then enters into sleep mode if there are
no any signal inputs within 30sec.
9 Press
START
button once the display enters pause mode. The buzzer will sound
for 0.5sec in every 30sec. All values are displaying on the display and are flashing
every 4sec. If training stops for 5 minutes, buzzer sounds for 2sec and enter sleep
mode. Press
START
to resume workout.
7 The above 3 & 4 continue cycle counting and add 1 per each cycle, until the
WORK
setting value is finished. It will then go to the end page.
10 Pressing
STOP
or ending training, the buzzer beeps for 1sec then displays
TOTAL
TIME, DISTANCE, CALORIES
for 30s, and
WATT, SPEED
&
RPM
will switch to
display
AVG
. &
MAX
. (Figure 18~19) each for 5sec.
11 Press any
PROGRAM
key then perform the program accordingly.
Figure 32
Figure 33
Figure 34
Figure 28
Figure 29
Figure 30
Figure 31
