7 - MAINTENANCE
Power Take-Off (PTO) clutch
The Power Take-Off (PTO) clutch engagement pres-
sure needs to be checked and adjusted to prevent slip-
page of the PTO during operation under load.
1. When the PTO clutch linkage is properly adjusted, the
PTO lever
(1)
should have
2 mm
(
0.079 in
) of free play
at pin
(A)
when the PTO handle is in the "OFF" position.
2. If the free play of lever is not correct, adjust by loos-
ening jam nut
(2)
and shortening or lengthening cable,
(3)
.
56061331N
1
3. Use a spring scale
(4)
to measure the force needed
to fully engage the PTO handle
(5)
. Proper amount of
force at end of handle to fully engage the PTO clutch is
125 - 142 N
(
28 - 32 lb
)
86090136N
2
NOTICE:
When PTO clutch linkage is properly adjusted, the total cable travel should be
21 mm
(
0.83 in
) while en-
gaging and disengaging the PTO clutch.
7-39
Summary of Contents for Workmaster 50
