F156.6 / F156.6A
SAFETY INSTRUCTIONS
0 - 21
Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual)
WORKING EQUIPMENT
PERSONNEL
Assembly work may be performed
only by operating or repair personnel
possessing the necessary know-
how.
In the case of insufficient knowhow,
meticulous instruction must be
given by experienced personnel, e.g.
by the Manufacturer.
The personnel must have read and
understood the operating instruc-
tions, especially the chapter "Funda-
mental safety instructions".
These people only may operate the
machine during installation, in order
to make corrections to the working
equipment.
Misuse or improper operation of the
machine or its working equipment
can be highly dangerous.
PERSONAL PROTECTIVE
EQUIPMENT AND WORKING
CLOTHES
Wear closely fitting working clothes
when working on the machine.
Loose, wide working clothes can
catch in machine parts and cause in-
jury.
Wear a safety helmet, protective
working boots and gloves.
TOOLS AND AUXILIARIES
Tools, lifting equipment, slings,
chocks and other equipment must be
in safe operating and working condi-
tion.
Metal splinters can cause injury
when accessory bolts are being
driven in and out. Therefore, a brass
or copper mandrel should be used
and protective goggles must be
worn.
When entering and leaving the cab,
use only the intended steps, plat-
forms and handrails.
Keep steps, platforms and handles in
safe condition for footholds and
handholds. Remove any oil, grease,
earth, clay, snow, ice other sub-
stances immediately.
SECURING WORKING EQUIPMENT
Set all working equipment down on
the ground, so that no movements
can occur if mechanical or hydraulic
connections become detached.
When working in jointed areas lock
the pivot joints. Remove the locks
when work is finished.
Secure any equipment or compo-
nents which are to be attached or de-
tached or whose position is to be
altered, with hoists or suitable
slinging/supporting devices to pre-
vent them from moving, slipping or
falling.