13
3.
Operation
3-1. Preparation
3-1-1. Battery installation
Units are shipped without batteries. Remove the battery cover and then install the four supplied
batteries. See “Battery Replacement” on pages 38 to 39 for the procedure.
The battery cover is pre-installed when shipped.
3-1-2. 1m gas sampling tube/drain filter/cooling drain filter installation
Connect the coupler of the gas sampling
tube drain filter/cooling drain filer to the gas
inlet of the gas detector. To remove the
coupler from the gas inlet, pull the sleeve
up to release.
Install the gas sampling tube’s probe
nozzle to the sampling tube holder as
shown in the right photo.
3-1-3. Shoulder strap installation
(1)
Separate the sub-straps from each other by opening the carabiner.
(2)
Attach each sub-strap to the detector by threading its
loop through the strap hole (2 places) located at the
bottom of the detector. *Attach the sub-straps while
the detector is installed in the elastomer case.
(3)
Reassemble the sub-straps into the shoulder strap
by closing the carabiner. *The shoulder strap length
can be changed with its adjuster.
3-1-4. How to use the stand
Lift the stand up such that the detector can stand
alone on the desk, etc. The stand can be opened
up to 90
.
Sampling tube
holder
Sleeve
Pull up the sleeve for removal
Stand
Strap hole
Press here to open
When carrying the detector
