7
DE
S
CRIP
TION OF UNIT & C
ONTROLS
3.0
Description of Unit & Controls
MediTens XP is easy to use. All buttons are push buttons. The functions are defined by icons
printed on each button (see below). MediTens XP has a built-in audio indicator that emits a
hig h-pitched tone when a valid button is pressed and a low tone when an invalid button is
pressed.
Buttons and Button Functions (Fig. 1)
MediTens XP has the following buttons and functions:
1. On / Off (Pause) Button ( )
This button switches the unit on and off and is also used to pause the treatment session. You
must press and hold the button (for 2 seconds) to switch the unit off at the end of a treatment.
2. Intensity Controls - Channels 1 and 2 ( / )
Each intensity control governs the channel on that side of the unit. Pressing the upper button
( ) during treatment increases the intensity level by a factor of one for that channel.
Similarly, pressing the lower button ( ) decreases the intensity level by a factor of one. The
numerical intensity indicator on the display changes in single increments to indicate this.
3. Program Select Button (P)
The Program Select button enables the user to select the required treatment program.
To change the program hold down the
program selection button (P) for at least 3 seconds.
4. Lock Button ( )
The Lock button allows the user to lock the intensity controls to prevent accidental changes in the intensity level. It is also used
to lock the Trigger button.
To set the Total Treatment Time.
To reset the total treatment time, press the lock button and the program selection button. The user must first press the Lock button
and then the Program Select button for approximately 3 seconds. A tone will sound and the display will reset to zero. This
function is available only at the start of a treatment session.
1
2
3
4
5
2
Fig. 1
English
MediTens XP IM W Europe_Layout 1 01/12/2010 12:29 Page 9