NX-1700E Card Reader
5
Scan: To
“present” or
pass a card or
FOB within
sensing range
of the card
reader module.
IV. ADDRESSING
Once the reader is wired into the system, the module needs to be addressed. Unlike most
NetworX expanders, the address of any particular reader is determined by itself after installation
is complete. Follow the procedures outlined under the section “PROGRAMMING”. When
prompted to enter the module device number, a card must be scanned at the reader to initiate
addressing (one short beep). When completed (1-2 seconds), the reader will beep back its
address (long beeps). Refer to Table IV-1 that follows for possible addresses.
Table IV-1
Beeps
Address
Beeps
Address
1 113 9 121
2 114 10 122
3 115 11 123
4 116 12 124
5 117 13 125
6 118 14 126
7 119 15 127
8 120
V. PROGRAMMING
A. USING THE LED KEYPAD
ACTION
RESULT
E
NTERING THE
P
ROGRAM
M
ODE
Enters the Program Mode.
Stay, Chime, Exit, Bypass & Cancel LEDS will
flash.
[
Go To Program Code
]
Factory Default is
If the "Go To Program Code" is valid, the "Service"
LED will flash and the 5 function LEDs will
illuminate steady. You are now in the Program
Mode and ready to select the module address.
E
NTERING THE
M
ODULE
A
DDRESS
Scan a card.
The card reader will address itself.
#
(example only)
Enters the module address. Refer to Table IV-1 on
page 5 for the address assigned by the card reader
module itself.
The Armed LED will illuminate while it is waiting for
a programming location to be entered.
