NX-1700E Card Reader
23
X. GLOSSARY
TERM
DESCRIPTION
Alternative Mode
Alternative mode is an optional scan method, as opposed to the default Legacy
mode (see below). The card is to be continuously held at the reader for a
specified number of beeps. Example: Hold the card at the card reader’s sensor
for a total of 2 beeps. This is a “double beep” in the alternative mode”. This
method becomes available when Location 272, Segment 1, Option 6 is disabled.
Double Beep………………. An audible indicator (beep, beep).
Double Beep Scan………..
When a user card is scanned and held at the reader for 2 beeps, the reader will
perform the functions as programmed in Location 241, Segment 4.
Legacy Mode……………… Legacy mode is used to describe the default operation of the card reader’s
scanning method. This mode uses the same scan methods as prior versions of
the card reader modules. Example: Pass a user card by the reader’s sensor,
remove it from the field, then pass the card by the reader’s sensor once again
during the time programmed in Location 244, Segment 1. This is a “double
scan” in the legacy mode.
Request To Exit (RTE)…… A zone can be programmed to monitor an open door. The RTE activates the
onboard open collector output and sends a message on the buss.
Scan……………………….
To “present” or pass a card or FOB within sensing range of the card reader
module.
Single Beep……………….. An audible indicator (beep).
Single Beep Scan………… When a user card is scanned and held at the reader for 1 beep, the reader will
perform the functions as programmed in Location 241, Segment 3.
Triple Beep………………... An audible indicator (beep, beep, beep).
Triple Beep Scan…………. When a user card is scanned and held at the reader for 3 beeps, the reader will
perform the functions as programmed in Location 241, Segment 5.
XI. FCC
INFORMATION
This device complies with Part 15 of the FCC rules. Operation is subject to the following three conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
3. Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
FCC ID: CGGNX-1700E
XII.
UNDERWRITERS LABORATORIES INFORMATION
The NX-1700E module has received the following UL listings:
UL294
Access Control Systems Units
