NX-1700E Card Reader
11
Segment 2
Program a number from 0-15 to represent the corresponding X-10 House code from the following
table. Default is 0.
X-10 ADDRESS CODES
0=A
4=E 8=I 12=M
1=B 5=F 9=J 13=N
2=C 6=G 10=K
14=O
3=D 7=H 11=L 15=P
Segment 3
Single Scan Function {Single Beep}
Program the X-10 function that is performed when a card is scanned {one beep}. This location only needs to be
programmed if Location 0, Segment 1, Option 7 is set. Use the following table. Default is 2.
Function #
Function performed
Function #
Function performed
0
All units off
4
Dim
1
All lights on
5
Bright
2 On 6
All lights off
3 Off
All
others
Reserved
Segment 4
Double Scan Function {Double Beep}
Program the X-10 function that is performed when a card is scanned twice within the 2 Scan Hold Time {two beeps}.
Location 244, Segment 1 programs the length of time between beeps. The descriptions of the function codes are the
same as for Single Beep Scan Function. This location only needs to be programmed if Location 0, Segment 2, Option 7
is set. Use the above table. Default is 3.
Segment 5
Single Scan Hold Function {Triple Beep}
Program the X-10 function that is performed when a card is scanned and held at the reader for the duration of the 2
Scan Hold Time {three beeps}. Location 244, Segment 1 programs the length of time between beeps. The
descriptions of the function codes are the same as for Single Beep Scan Function. This location only needs to be
programmed if Location 0, Segment 3, Option 7 is set. Use the above table. Default is 2.
L
OCATION
242 P
ROGRAMMING THE
O
PTIONS AND
R
EADER
P
ARTITION
(4 segments of binary data)
Segment 1
System Options:
LED1 - "On" if reader is enabled for User Card Programming.
LED2 - "On" if optical tamper is enabled.
LED3 - "On" if reader buzzer is to follow typical keypad buzzing. (Default is “On”)
LED4 - "On" if ding-dong chime enabled (dependent on both Option 3 and chime being enabled).
LED5 - “On” if an RTE from a scanned card is to be logged as Code Entry. (Default is “On”)
LED6 - “On” if reader is in NX-1700E Legacy Mode (Default is “On”) Refer to note below.
LED7 - “On” if an RTE) from a zone or the Egress input is to be logged as Code Entry.
LED8 - Reserved.
The card reader is defaulted to the “Legacy mode”. This mode uses the same scan method as
previous NX-1700E card readers. However, an alternative scan method is available by turning
off LED6 in Location 242, Segment 1. Rather than passing the card (scan) within range of the
card reader, the card can be held at the reader for a specified number of beeps.
Example of Double Scan: Legacy mode -- Pass the card by the reader’s sensor, remove it from
the sensor area, then pass the card by the reader’s sensor once again. Alternative mode -- Hold
the card at the card reader for a total of 2 beeps. Refer also to the Glossary on page 24.
IMPORTANT: If you have older models installed in the system without this enhanced feature, it
could result in two different methods of scanning at various readers.
