Network Appliance DiskShelf 14mk2 FC, Hardware And Service Manual

Page: 64 / 106

54 Replacing an LRC/ESH/ESH2/ESH4 module
Replacing an LRC/ESH/ESH2/ESH4 module
Installing a module
Installing an
module To install a module into the disk shelf, complete the following steps.
Caution
Observe the “ Disk shelf cabling requirements ” on page 34 and do not mix
LRC/ESH/ESH2/ESH4 modules within a shelf.
Step Action
1 Verify that your NetApp appliance meets the minimum software
requirements to support the disk shelf and module combination. See
the System Configuration Guide at
http://now.netapp.com for more
information.
2 Put on the antistatic wrist strap and grounding leash.
3 Push apart the levers on the CAM mechanism and slide the module
into the slot at the rear of the disk shelf, then push the levers of the
CAM mechanism into place.
Caution
Do not use excessive force when sliding the module into the disk
shelf; you might damage the connector.
4 Reconnect the Fibre Channel cabling.
5 Turn on the power to the disk shelves.
6 Reboot the storage controller.