SIP 60X User Manual
Page 42 of 43
address, power cycle the ATA, the firmware will be fetched once the ATA boots up.
To configure the TFTP server via the Web configuration interface, open up your browser to
point at the IP address of the SIP 60X. Input the admin password to enter the configuration
screen. From there, enter the TFTP server address in the designated field towards the
bottom of the configuration screen.
Once the TFTP server is configured, please power cycle the SIP 60X.
TFTP process may take as long as 1 to 2 minutes over the Internet or just 30+ seconds if it
is performed on a LAN. Users are recommended to conduct TFTP upgrade in a controlled
LAN environment if possible.
NOTES:
When SIP 60X boots up, it will send TFTP or HTTP request to download configuration files,
there are two configuration files, one is “cfg.bin” and the other is “cfg001fc1xxxxxx”, where
“001fc1xxxxxx” is the MAC address of the SIP 60X. These two files are for initial
automatically provisioning purpose only, for normal TFTP or HTTP firmware upgrade, the
following error messages in a TFTP or HTTP server log can be ignored.
9 RESTORE FACTORY DEFAULT SETTINGS
WARNING!
Restoring the Factory Default Setting will DELETE all configuration
information of the phone.
Please BACKUP or PRINT out all the settings before you approach to following steps.
Netronix will not take any responsibility if you lose all the parameters of setting and cannot
connect to your VoIP service provider.
FACTORY RESET
There are two (2) methods for resetting your unit:
Reset Button
Reset default factory settings following these four (4) steps:
1. Unplug the Ethernet cable.
2. Locate a needle-sized hole on the back panel of the gateway unit next to the power
connection.
3. Insert a pin in this hole, and press for about 8 seconds.
4. Take out the pin. All unit settings are restored to factory settings.
