SIP 60X User Manual
Page 13 of 43
2. Dial the number directly and press # (Use # as dial key” must be configured in web
configuration).
Examples:
1. Dial an extension directly on the same proxy, and then press the # or wait for 4 seconds.
2. Dial an outside number, first enter the prefix number (usually 1+ or international code)
followed by the phone number. Press # or wait for 4 seconds. Check with your VoIP
service provider for further details on prefix numbers.
5.2.2 Direct IP Calls
Direct IP calling allows two parties, that is, a FXS Port with an analog phone and another
VoIP Device, to talk to each other in an ad hoc fashion without a SIP proxy.
Elements necessary to completing a Direct IP Call:
1. Both SIP 60X and other VoIP Device, have public IP addresses, or
2. Both SIP 60X and other VoIP Device are on the same LAN using private IP addresses,
or
3. Both SIP 60X and other VoIP Device can be connected through a router using public or
private IP addresses (with necessary port forwarding or DMZ).
SIP 60X supports two ways to make Direct IP Calling:
Using IVR
1. Pick up the analog phone then access the voice menu prompt by dial “***”
2. Dial “47” to access the direct IP call menu
3. Enter the IP address using format ex. 192*168*0*160 after the dial tone.
Using Star Code
1. Pick up the analog phone then dial “*47”
2. Enter the target IP address using same format as above.
Note: NO dial tone will be played between step 1 and 2.
Destination ports can be specified by using “*” (encoding for “:”) followed by the port
number.
Examples:
a) If the target IP address is 192.168.0.160, the dialing convention is
*47 or Voice Prompt with option 47, then 192*168*0*160.
Followed
by pressing the “#” key if it is configured as a send key or wait 4 seconds. In this
case, the default destination port 5060 is used if no port is specified
.
b) If the target IP address/port is 192.168.1.20:5062, then the dialing convention would be:
*47 or Voice Prompt with option 47, then 192*168*0*160*5062
followed by pressing the
“#” key, if it is configured as a send key or wait for 4 seconds.
NOTE:
When completing direct IP call, the “
Use Random Port
” should set to “NO”. You
cannot make direct IP calls between FXS1 to FXS2 since they are using same IP.
