Management
50
ProSAFE Dual Band Wireless N Access Point WNDAP350
Remote Management
Both the SNMP and Remote Console are enabled by default, which allows for remote
management of the WNDAP350 from a client running SNMP management software, as well
as from a secure Telnet console.
To set up an SNMP management interface:
1.
Under the
Maintenance
tab, select
Remote Management
, and then select
SNMP
from
the left sidebar. The SNMP screen displays, as shown in
Figure 27, Configure SNMP
settings
below:
Figure 27. Configure SNMP settings
2.
Enter the following information in the SNMP fields:
•
SNMP
. Enable SNMP to allow the SNMP network management software, such as HP
OpenView, to manage the wireless access point via SNMPv1/v2 protocol.
•
Read-Only Community Name
. The community string to allow the SNMP manager to
read the wireless access point's MIB objects. The default is Public.
•
Read-Write Community Name
. The community string to allow the SNMP manager
to read and write the wireless access point's MIB objects. The default is Private.
•
Trap Community Name
. The community string to allow the SNMP manager to send
traps. The default is trap.
•
IP address to Receive Traps
. The IP address of the SNMP manager to receive traps
sent from the wireless access point.
•
Trap Port
. The port number on which the SNMP Manager will receive traps. The
default is 162/UDP.
