NetComm NWL-12-01, User Manual

Page: 98 / 142

98
NetComm Wireless 3G Light Industrial M2M Router www.netcommwireless.com
get ledmode get ledmode Returns the status of the LED operation mode.
set ledmode set ledmode=10
Sets the LED operation mode to be always on or to turn off after the specified number of
minutes.
get ssh.proto get ssh.proto Returns the SSH protocol in use.
set ssh.proto set ssh.proto=1,2 Sets the SSH Protocol to protocol 1, 2 or both (1,2).
get ssh.passauth get ssh.passauth Returns the status of the SSH Enable password authentication option.
set ssh.passauth set ssh.passauth=1 Sets the SSH Enable password authentication option on or off.
get.ssh.keyauth get.ssh.keyauth Returns the status of the SSH Enable key authentication option.
set.ssh.keyauth set.ssh.keyauth=1 Sets the SSH Enable key authentication option on or off.
Table 25 - List of get/set commands
List of basic RDB variables
The following table lists valid variables where “x” is a profile number (1-6). If no profile is specified, variables are read from or written
to for the current active profile. If a profile is specified, variables are read from or written to for the specified profile number (‘x’).
# RDB VARIABLE NAME
SMS VARIABLE
NAME
READ/
WRITE
DESCRIPTION EXAMPLE VALUE
0
link.profile.1.enable
link.profile.1.apn
link.profile.1.user
link.profile.1.pass
link.profile.1.auth_type
link.profile.1.iplocal
link.profile.1.status
profile RW Profile
Read:
(profile no,apn,user,pass,auth,iplocal,status)
1,apn,username,password,
chap,202.44.185.111,up
Write:
(apn, user, pass,auth)
apn,username,password
2 link.profile.1.user username RW 3G username Guest, could also return “null”
3 link.profile.1.pass password RW 3G password Guest, could also return “null”
4 link.profile.1.auth_type authtype RW
3G Authentication
type
”pap” or”chap”
5 link.profile.1.iplocal wanip R WAN IP address 202.44.185.111
6 wwan.0.radio.information.signal_strength rssi R 3G signal strength -65 dBm
7 wwan.0.imei imei R IMEI number 357347050000177
8 statistics.usage_current usage R
3G data usage of
current session
“Rx 500 bytes, Tx 1024 bytes, Total 1524
bytes” or “Rx 0 byte, Tx 0 byte, Total 0 byte”
when wwan down
9 statistics.usage_current wanuptime R
Up time of current 3G
session 1 days 02:30:12 or 0 days 00:00:00 when
wwan down
10 /proc/uptime deviceuptime R Device up time 1 days 02:30:12
11
wwan.0.system_network_status.current_ba
nd
band R Current band WCDMA850
Table 26 - List of basic SMS diagnostics RDB variables
Network scan and manual network selection by SMS
Performing a network scan
The get plmnscan SMS command enables you to perform a scan of the cellular networks available at the time of the scan.
It returns the following semi-colon separated information for each network in range:
MCC
MNC
Network Type (3G, 2G)
Provider's Name
Operator Status (available, forbidden, current)