Ness Security Products Securityguard III, Programming Manual

Page: 22 / 30

Doc ID. SG3PROG00103_03_2014.DOC 22
PHONE1
PHONE NUMBER 1 (default = -)
Dialler function is enabled when PHONE1 is programmed (i.e. not ‘-’).
Up to 20 digits can be programmed. After a period of 30 days following PROGRAM mode
EXIT, this option can only be reprogrammed via remote Up/download (option hidden in local
PROGRAM mode).
•
Press ON to view programmed phone number, which will scroll across the display, after
which 2 beeps will occur and the first digit will be flashing.
•
Press OFF to leave the number unchanged and step to the next option.
•
Press ON to step through values for the first digit:
- PAUSE
0-9 digits 0-9
* STAR
# HASH
•
Press PANIC to store the first digit. The second digit will flash.
•
Repeat for each digit (the display will scroll left after the fourth digit is entered).
•
Press ON to store the last digit, then press OFF.
The programmed phone number will scroll across the display, after which 2 beeps will
occur and the first digit will be flashing.
•
Press OFF to step to next option, or repeat procedure to make corrections.
PHONE2
PHONE NUMBER 2 (default = -)
Same as PHONE NUMBER 1.
ABORT
DIALLER ABORT DELAY (default = 15)
Gives the opportunity to abort sending an alarm message to the monitoring station within the
programmed time (i.e. cancel a false alarm).
0-60 Time in seconds, 5 second steps
MEDIC
MEDICAL KEY ABORT DELAY (default = 20)
Gives the opportunity to abort sending a Medical alarm message to the monitoring station
within the programmed time (i.e. cancel a false alarm).
0-60 Time in seconds, 5 second steps
T-CALL
DIALLER TEST CALL (default = 7)
If enabled, the first test call is sent 14 hours after PROGRAM mode EXIT.
OFF
Test calls disabled
1,7,14,
30 Test call period in days