Ness Security Products Securityguard III, Programming Manual

Page: 30 / 30

Doc ID. SG3PROG00103_03_2014.DOC 30
•
Programming the SGIII Radio Dialler: Program the CLIENT, PHONE 1 and PHONE 2 options into the SGIII.
Once the above is done continue through the program options until P-EXIT is on the display. At this point,
power up the radio dialler with both mains and battery. The Radio Link light will double flash. Exit SGIII
program mode by pressing “ON” on a programmed radio key. This will drop SGIII out of program mode and
download the customer and central station information to the Radio Dialler. The radio dialler will respond by
flashing out the signal strength on the indicator lights as well as beeping the signal level. For testing purposes
only, place a shorting link on J6 of the radio dialler. This will allow you to hear the dialler call and respond to
the central station tones and then hang up after sending the message. Don’t forget to remove the link on J6
after testing to the central station. To test SGIII to Radio dialler signal strength from this point on, simply put
the SGIII into program mode. Cycle through until P-EXIT is on the display then press the “ON” button on any
programmed key to exit program mode and the radio dialler will display and beep out the signal strength.
•
You may find sometimes that when you turn OFF the Emergency Override Key and turn it back on that
nothing happens. This is due to the high impedance of the circuit and that the capacitors need more time
discharge. If you encounter this there are two ways to overcome it: 1) Wait a little longer (10-15 seconds)
before turning the EOR key back ON. 2) Turn the EOR key OFF when the display is on. This will discharge
the capacitors quicker.