Nera SatLink 1000, User Manual

Page: 57 / 120

Nera SatLink Terminal User Guide – Revision P
55
Example:
# sw license pep mykeyforenablingpep
# ip pep server 10.0.0.10
# ip pep enable redirect
# ip pep show
(to verify that the functionality is enabled)
PEP Status : enabled
PEP Mode : Redirect Mode
PEP Server Address : 10.0.0.0
Maximum Connections : 250
Current Connections : 2
Total Connections : 1764
Transp Connections : 0
Failed Connections : 0
#
The CLI command
i
p pep show
displays current PEP configuration in addition to certain PEP status
information. Table 10 provides a short description of the displayed parameters.
Parameters Description
PEP status Indicates whether the PEP functionality in the terminal is enabled or disabled.
PEP Mode Indicates whether the terminal is configured in Redirect or Transparent Mode
PEP ServerAddress Shows that IP address of the Gateway PEP Server that the terminal PEP client
is configured to interact with.
Maximum Connections Shows that maximum number of TCP connections that the terminal PEP client
can handle simultaneously. The value is 250 connections.
Current Connections Indicates the number of TCP connections that is handled by the terminal PEP
client at the moment.
Total Connections Indicates the total number of TCP connections that has been handled by the
PEP client since the PEP functionality was enabled.
Trans Connections Once the number of connections exceeds the threshold Maximum Connections
(i.e. 250 connections), the additional new connections are established without
performance enhancement techniques being applied to these. The parameter
Trans Connections indicates the number of connections that are passed
“transparently” through the terminal without PEP due to the Maximum
Connection threshold being exceeded.
Failed Connections Indicates the number of connections that were attempted established, but did
not succeed.
Table 10 Parameters displayed when typing
ip pep show