Nera SatLink 1000, User Manual

Page: 19 / 120

Nera SatLink Terminal User Guide – Revision P
17
5. Using the Command Line Interface of the SatLink Terminal
The command line interface can be accessed via either Telnet or the RS-232 port for management of the
Nera SatLink Terminal as well as for showing status and reports.
5.1 Start-up sequence
When turning on the Nera SatLink Terminal first the Boot SW is loaded. A message such as the one
below is displayed on the CLI/RS-232 when the boot SW starts. Note that Telnet is not available before
the application has been started.
Nera SatLink Boot-loader
- SW ID 106267, Revision 9.0.0.1
File system initialised
Press return to enter boot-loader
Under normal circumstances the user should not need to enter the boot-loader and should ignore the
“press return to enter boot-loader” message. The DVB RCS application will load automatically once the
boot SW load has completed. See Appendix I for further details concerning the boot SW. If access to the
boot-loader is required, press return within 10 seconds to display the login-prompt for entering the boot-
load.
After the timer has expired, the DVB-RCS application will be loaded. The message
Loading
application
will be shown when the application starts to load.
When the DVB-RCS application starts to run a message similar to this will be shown:
Nera SatLink 1000
- Main Board ID 102805, Revision R6.0
- SW ID 101224, Revision 9.1.3 Build 56
The application will then initialise the file system, restore all configuration parameters from flash, do
initial configuration, and start the DVB-RCS receiver and transmitter if these are configured to start
automatically.
The following messages on CLI show when the Nera SatLink Terminal has successfully restored all
configuration parameters from the MIB (from the configuration file on the flash file system), when lock
on the forward link is achieved, and when successful DVB-RCS logon has been achieved:
State : CLI message
Configuration completed
:
Retrieving configuration....done
Lock on forward Link achieved
:
Forward link up
Successful logon
:
Return link up
Two-way link established