●
BDM-300X2-EU (Europe)
L1 to L2
230 Vac
2. Mount the adapter plate at a suitable loca
�
on on the PV racking system (typically
at the end of a row of modules).
3. Install an appropriate junc
�
on box with the adapter plate.
4. Connect the open wire end of the AC interconnect cable into the junction box using
an appropriate gland or strain relief
fi�
ng. The AC interconnect cable requires a
strain relief connector with an opening of 3/8 inches in diameter.
Step 2 - A
�
ach BDM-300X2 t
o
the Racking
1. Mark the approximate centers of each PV module on the racking system. Evaluate
the loca
�
on of the micro inverter with respect to the PV module junc
�
on box or any
other obstruc
�
ons.
WARNING:
ALLOW A MINIMUM OF 2.75 INCHES BETWEEN THE TOP OF THE ROOF AND THE
BOTTOM OF BDM-300X2, AND ALSO A MINIMUM 2.75 INCHES BETWEEN THE BACK OF THE PV
MODULE AND THE TOP OF BDM-300X2. DO NOT MOUNT BDM-300X2 IN A LOCATION THAT
ALLOWS LONG-TERM EXPOSURE TO DIRECT SUNLIGHT.
2. Mount one micro inverter at each of these loca
�
ons using hardware recommended
by your module racking vendor
Step 3 - C
o
nnect the BDM-300X2 Wiring Harnesses
Each BDM-300X2 comes with one 3-pin bulkhead receptacle mounted on the
case. The three pins of this connector are for phases L1, L2 and ground. This AC
connector is oppositely sexed with the connector at the end of the extension
cable from the trunk cable through a T-connector. Plug the AC connector of the
each BDM-300X2 into the connector of the extension cable to form a con
�
nuous
AC branch circuit. Please check the ra
�
ng label of the trunk cable for the
maximum allowable number of BDM-300X2 on one AC branch circuit.
WARNING:
DO NOT EXCEED THE MAXIMUM NUMBER OF BDM-300X2 IN AN AC BRANCH
CIRCUIT, AS DISPLAYED ON THE UNIT-RATING LABEL. For 12AWG trunk cable, EACH BDM-
300X2 AC BRANCH CIRCUIT MUST BE SOURCED FROM A DEDICATED BRANCH CIRCUIT
PROTECTED BY A 20A MAXIMUM BREAKER.
Install a protec
�v
e end cap on the open AC connector at the end of the truck
cable.
WARNING:
MAKE SURE PROTECTIVE END CAPS HAVE BEEN INSTALLED ON ALL UNUSED
AC CONNECTORS. UNUSED AC BDM-300X2 WIRE HARNESS CONNECTORS ARE LIVE WHEN
THE SYSTEM IS ENERGIZED BY THE UTILITY SYSTEM.
07
06
