4. INSTALLATION
WARNING:
BE AWARE THAT INSTALLATION OF THIS EQUIPMENT INCLUDES RISK OF
ELECTRIC SHOCK. NORMALLY GROUNDED CONDUCTORS MAY BE UNGROUNDED AND
ENERGIZED WHEN A GROUND FAULT IS INDICATED.
Parts Included
In addi
�
on to the micro inverters, PV modules, racking, and associated hardware,
you’ll need the BDM-300X2 installa
�
on kit. This kit includes the following items:
●
Protec
�v
e end cap
●
Moun
�
ng Bracket (adapter plate)
●
AC trunk cable, 6 feet length (op
�
on)
Other Parts and T
oo
ls Required
In addi
�
on to your PV array and its associated hardware, you will need the
following parts:
●
Junc
�
on box
●
Sockets, wrenches for moun
�
ng hardware
Lightning Surge Suppressi
o
n
Lightning does not actually need to strike the equipment or building where PV
system is installed to cause damage. O
�
en, a strike nearby will induce voltage
spikes in the electrical grid that can damage equipment. BDM-300X2 has
integrated surge protec
�
on, greater than most string inverters. However, if the
surge has su
ffi
cient energy, the protec
�
on built into the BDM-300X2 can be
exceeded, and the equipment can be damaged.
Since the NEP Limited Warranty does not cover “acts of God” such as lightning
strikes, and since lightning strikes can occur anywhere, it is best prac
�
ce to install
surge protec
�
on as part of any solar installa
�
on. Installa
�
on of surge protec
�
on
devices should follow vendor instruc
�
ons.
Installa
�o
n Pr
o
cedure
WARNING:
DO NOT CONNECT BDM-300X2 TO THE UTILITY GRID OR ENERGIZE THE AC
CIRCUIT(S) UNTIL YOU HAVE COMPLETED ALL OF THE INSTALLATION PROCEDURES AS
DESCRIBED IN THE FOLLOWING SECTIONS.
Installing the BDM-300X2 Micro inverter System involves several key steps:
1. Measuring service and installing the AC branch circuit junc
�
on box.
WARNING:
ONLY USE ELECTRICAL SYSTEM COMPONENTS APPROVED FOR WET
LOCATIONS.
2. A
�
aching the BDM-300X2 Micro inverter to the racking.
3. Connec
�
ng the BDM-300X2 Micro inverter wiring harnesses.
4. Grounding the system (op
�
onal)
1
.
5. Comple
�
ng the BDM-300X2 Micro inverter installa
�
on map and connec
�
ng
the PV modules.
The
fi
nished system should be similar as in the diagram. Detailed installa
�
on steps
are listed in the following sec
�
on.
Step 1 - Install the AC Branch Circuit Junc
�o
n B
o
x
1. Measure service entrance conductors to con
fi
rm AC service at the site.
Acceptable ranges are shown in the table below:
●
BDM-300X2-240A & BDM-300X2-208A (North America)
240 Volt AC Single Phase
208 Volt AC Three Phase
L1 to L2
240 Vac
L1 toL2
208 Vac
●
BDM-300X2-AU (Australia and New Zealand)
L1 to L2
230 Vac
1
DC circuits of BDM-300X2 are isolated and insulated from ground. An
integrated ground protec
�
on circuit is included in the micro inverter.
04
05
04
