32
MaxiMailer HD Operator Manual
5.9.4 setting
the feed
options for the
feed unit
Press the lower icon of the numbered feed unit (showing the unit icon),
and the following dialog box appears:
address Carrier:
Select whether or not this is the address document
(this will normally be the DTI).
note:
this can also be selected
from ‘Miscellaneous’ (see page
37). Whichever is set the later takes
precedence.
feed Control Mode:
Options are: Off / Feed Always / OMR or Barcode
Select (the latter only available if unit is OMR/Barcode enabled).
see
OMR/Barcode User’s Manual for defining barcode setups. Note:
OMR or barcode reading are optional features.
flip mode (DTI only):
Options are Flip / No-flip. Select no-flip if form
is required to feed straight through without turnover.
fold Mode (not applicable to DTI):
(Tower folder only) Options are:
Singly / Together / Via accumulator (the latter is only available if the
unit has an accumulator fitted: if so, forms will group in accumulator
first before folding.only).
form Count (not applicable to DTI):
Only available if ‘Mark reading’
is Off. If multiple forms are required, set this to the required quantity.
note:
ensure that the maximum fold capacity is not exceeded.
Reader (Head) ID:
Only available if ‘Mark reading’ is On. Options are
Reader (Head) 1 / Reader (Head) 2 / Both readers. Only available if
two read heads are fitted.
Mark Reading:
Only available if unit is OMR/Barcode and a marked
document is selected. Options are: Off / OMR marks / Barcode labels /
2D Datamatrix / OCR.
Note that the options
in the dialog box may
vary from those shown,
depending on whether the
unit is a feeder or a folder.
Select ‘Save as Default’
to make this the default
for all new setups. These
settings then apply to ‘Load
Default’