Radiator Laser Synthesizer
User Manual
Blink Mode
The blink mode affects whether a SELECT button will blink when a module is selected. This is
completely for personal preference.
LED and LCD Brightness
The LEDs on the panel as well as the LCD backlight can be adjusted in overall brightness. This can be
useful for operating in very dark rooms.
IP Address
The IP address of the unit is displayed in the IP Address line of the screen. Please note that currently
Radiator supports DHCP and Link-Local address setting only. It may be necessary to restart Radiator
after a DHCP lease has been acquired to cause it to be reset for use with Link-Local networks.
Analog Inputs
To check for proper audio and CV input levels the Analog Inputs item can be selected. This will cause a
levelmeter display to appear at the top of the screen indicating the audio input levels (Audio in L and
R) and the CV input DC levels. (CV in 1-6)
MIDI Control
The MIDI control parameters affect the MIDI control of parameters using CC and Program Change
messages. Make sure to set the MIDI control channel differently than the Panel MIDI channel to avoid
conflicts. (see Appendix B)
Panel MIDI
The Panel MIDI parameters affect the MIDI control over panel knobs and buttons via MIDI. The
channel sets the base channel and can be set from channel 1-14 because LED values require 3 channels
to send the R, G and B values. (see Appendix A) The Panel MIDI TX option affects whether LED
values will be sent. The Panel MIDI RX option affects whether panel MIDI knobs and button events
will be received.
Panel Test
To confirm proper operation of the panel knobs and buttons, the Panel Test mode can be used. SELECT
the Panel Test option in the menu and press ENTER. All LEDs will flash. Knob and button actions will
be shown at the top of the screen. Press ENTER again to stop the panel test mode.
Software ver. 1.0 and above - 2020-09-03
Page 40 of 66
www.neoncaptain.com