STEP 1.
Inspect shipping package and contents to ensure no
damage has occurred during shipping.
STEP 2.
Install Surface/Suspension Mount Brackets using the
8x M6 hex cap bracket mounting screws. See diagram
for orientation of brackets. Torque M6 bolts to 5 Nm
(45 in-lbs).
STEP 3.
A) For surface mounting configuration, mount lumi-
naire in desired locations using 4x 1/4-20 OR 4x M6
fasteners and washers (Not provided). One mounting
hole on each bracket is keyed to allow partial pre-in-
stallation of two fasteners for ease of install.
B) For ceiling mounting configurations, connect 4x
anchors to the 12.7mm (0.5”) holes. Suspension hard-
ware (Not provided) must be rated for a minimum of
180 lbs.
STEP 4.
Open XR Wiring Cover and allow cover to hang via
retention strap.
Note:
Screws are captive fasteners and will remain attached
to the cover for ease of reinstall and to prevent loss of
fasteners.
5.0in
126mm
5.2in
132mm
16.0in
405mm
17.3in
441mm
0.5in
12.7mm
0.3in
6.8mm
0.5in
12.7mm
0.5in
12.7mm
0.5in
12.7mm
0.5in
12.7mm
SURFACE/CEILING MOUNT INSTALLATION
Refer to alternate instructions if using Conduit, Hook, Wall, Pole or Yoke Mount
Step 2
Step 3A
Step 3B
TM
Nemalux
I N D U S T R I A L
XR-GEN
rev. A-13
2-14
www.nemalux.com | [email protected] | Tel 403•242•7475 | Fax 403•243•6190
MADE IN CANADA
WARNING
To reduce the risk of electric shock, disconnect the luminaire
from the supply circuit before opening for installation and
servicing. Keep tightly closed when in operation.
WARNING
To avoid the risk of fire, explosion, or electric shock, this
product should be installed, inspected, and maintained
by a qualified electrician only, in accordance with all
applicable electrical codes.
