Nederman FlexPAK, Setting Manual

Page: 27 / 55

FlexPAK
4.2 Parameter settings
4.2.1 Adjust the time and date
ESC OK
Thu 10:45
2018-02-01
ESC OK
FlexPak
Hi Vacuum Unit
OFF
Time To Service
2000 hours
ESC OK
Stop >
Program >
Setup >
Network >
Diagnos cs >
Setup >
ESC OK
Msg Config >
Start Screen >
Clock >
LCD >
Menu Language >
Switch to OP
Clock >
ESC OK
Set Clock >
S/W me >
Sync >
Set Clock >
Thu 10:45
2018-02-01
ESC OK
Set Clock
Do the following to adjust the time and date:
1 From the PLC status screen, press the Down arrow to go to the date and time screen.
2 Press Escape to go to the main menu.
3 Press the Down arrow to go to Setup. Press OK to confirm.
4 Press the Down arrow to go to Clock. Press OK to confirm.
5 Press the Down arrow to go to Set Clock. Press OK to confirm.
6 Use the Left and Right arrows to move the cursor to the parameter value. Press OK to confirm.
7 Use the Up or Down arrows to set Time or Date. Press OK to confirm. Weekday is automatically set by the
date.
8 Press Escape 3 times to go to the time screen.
9 Press the Up arrow to exit.
There are several other input menus on the same level as the date and time screen. If pressing the Down
arrow takes the PLC to one of those menus, use the Left arrow to get to the date and time screen.
4.2.2 Set the weekly timer
The weekly timer sets the unit to “Stand By” mode and “Off Mode” at preset times. If the pilot signal “PS” is act-
ive and the Vacuum unit is in Standby mode, the unit starts.
ESC OK
Thu 10:45
2018-02-01
ESC OK
Stop >
Program >
Setup >
Network >
Diagnos cs >
Program >
ESC OK
Set Parameter
Program Name Set Parameter
ESC OK
WeekTmr 1/2
D1 = MTWTF
On1 = 00:00
Off1 = -- --
D2 = MTWTF
On2 = -- --
ESC OK
WeekTmr 2/2
Off2 = -- --
D3 = - - - - -SS
On3 = -- --
Off3 = -- --
Pulse = Off
ESC OK
FlexPak
Hi Vacuum Unit
OFF
Time To Service
2000 hours
ESC OK
WeekTmr >
PresepTm >
MFDPS-Wr >
MFDPS-FC >
BLI-Empt >
BLI-Wr Z
27