9
MEDIA INSTALLATION
•
Media must be setup as per instructions.
•
The media is designed and shaped to correctly locate and remain in the correct position.
•
Do not add extra media, or combine media types.
•
Only the approved supplied media is to be used.
•
Do not use any other media than as supplied and recommended by the manufacturer. Use of
other media may result in explosive media which may cause injury or damage.
Fitting of the ceramic “log” set, Natural Gas model
•
Open the fire box front door of the unit by removing the locking screw at the base of the main
handle.
•
Remove the inside glass by loosening the two screws of the left hand glass retainer bracket.
Remove the two screws and right hand glass retainer bracket. Slide glass to the right a little,
then out.
Note: Take care not to chip edge of glass and be careful of sharp edges.
•
Unpack the log set and ember wool. There should be 3 Ceramic “logs” and a small bag of fibre
wool. The base board should be sitting on top of the burner.
•
Place the large flat rear log (3) with its cross hatched surface to the front on the two supports at
the back of the burner leaning against the rear of the firebox
.