6
SEQUENCE OF OPERATION
Turning the heater ON
1. Check that the gas and electricity is turned on.
2. Open the fold down control panel in the front of the pedestal.
(The glass door is fixed and does not open).
There are three switches to operate the fire:
𝑶𝑭𝑭
𝑶𝑵
𝑭𝑨𝑵 𝑯𝑰𝑮𝑯
𝑭𝑨𝑵 𝑳𝑶𝑾
𝑭𝑰𝑹𝑬 𝑯𝑰𝑮𝑯
𝑭𝑰𝑹𝑬 𝑳𝑶𝑾
3.
Always start the fire with the fire set on HIGH (RH switch up), and the fan on LOW (Middle switch down).
4.
Turn the ON/OFF switch to ON.
•
The controller will automatically turn on the gas and spark at the rear of the burner. After
a few seconds the gas will ignite.
•
If no flame is detected the gas is automatically turned off. If this happens, the heater is
reset by simply turning the
ON/OFF
switch to OFF, wait 30 seconds, and then turn ON
again.
•
The burner of the fire will light with a soft blue flame. You may see some moisture
appearing on the inside of the heater glass. This will disappear after about a minute as
the heater warms up. Leave the fire on HIGH and after about ten minutes the top of the
flames will become more orange like a real log fire.
5. The fan may be set on high or low at any time according to personnel taste after the heater has
warmed up.
6. If the room becomes too hot, the fire can be turned down simply by pressing the right-hand
Fire
Low
Switch.
Turning the heater OFF
To turn the heater off simply press the left hand switch to OFF and the burner and fan will both be turned
off.