Necta Korinto UL 120V, Installation, Use And Maintenance Manual

Page: 26 / 100

© by N&W GLOBAL VENDING SpA
22
07 06 275- 00
FUNCTIONS COMMON TO ALL SYSTEMS
Immediate change
Normally, the amount of a selection is cashed after the
machine sends the message “Selection successful”.
When this function is enabled, disabled by default, the
cash message is sent at the beginning of dispensing.
Decimal point
Press the confirm button “ ” to display the position of the
decimal point, i.e.:
0 decimal point disabled
1 XXX.X
2 XX.XX
3 X.XXX
Press the confirm button “ ”, these values will start blink-
ing and can then be modified as necessary.
SELECTIONS
The selection menu is composed of various sub-menus
which allow setting of the different parameters regard-
ing the composition of selections and to which buttons
they are to be associated.
Powder dose
The powder dose expressed in grams can be set for each
selection button, for each product that composes such
selection.
For correct conversion of product dose values, the flow
rate of the single doser units, expressed in g/s, can be
set to calculate the amount of powder to be dispensed.
Selection status
Each single selection button can either be enabled or
disabled.
Button-Selection
Permitting the association of a selection number,
indicated in the the selection dose table, to a button in
the direct selection keypad.
Checking selection number
Verifying the selection number associated to a button.
VENDING MACHINE PARAMETERS
This group of functions controls all parameters concerning
the machine operation.
TECH>
SET PARAMETERS
TECH>
SELECTIONS
TECH>
SET PARAMETERS
TECH>
MACHINE PARAMETERS
Water dose
The water dose (expressed in cc - FB - IN or “flow-meter
pulses” according to the models) can be set for each
selection button and therefore for each product assigned
to such selection.
Whipper Control
The whipping time can be set for each selection button, for
each water dose that composes such selection.
The duration can be set in two different modes:
Absolute
i.e. independent from the solenoid valve opening time. The
whipping duration is set as tenths of a second for Instant
models and as volumetric counter pulses for Espresso
models.
Relative
i.e. based on the difference, plus or minus, from the
moment the solenoid valve closes.
The whipping duration is always expressed in tenths of a
second.
Solenoid valve settings
It is possible to set (IN - FB) the water flow rate of the single
solenoid valves expressed in cc/s (the default value set-
ting in cc/s is indicated in the selection dose table) to
calculate the amount of water to be dispensed.
Boiler temperature
This function is used for setting the operating temperature
of the boiler, expressed in °C.
After selecting the boiler, press the confirm button “ ”, the
temperature value on the display will start blinking and can
be modified as necessary.
Tank
The machine water supply can be from the mains or from
an internal tank.
With this function it is possible to define whether the
machine water supply is from the mains (tank = 0FF), from
the tank with water level sensor (tank = ON) from the tank
without water level sensor (equipped base cabinet).
Enabling the wash button
With this function it is possible to enable the operation of
the mixer wash button.
Normally the button is disabled.
Power on controls
It is possible to enable/disable (ON/OFF) the request of
control messages regarding the status of the machine
(Tubing...?, Mixers...?, etc.) with subsequent pressing of
the confirm button.
Buzzer
If this function is enabled, the machine emits a sound
signal when the button are pressed and at the end of the
selection.