6-4 Problem Solving
If an error message appears before the operating system
starts, look up the error message in the following table.
Follow the instructions. If you see other error messages, the
hardware might need repair.
NOTE: When the Versa detects an error related to
display devices, it cannot display on either the LCD
or a CRT. The system warns you by beeping.
POST Error Messages
MESSAGE
WHAT TO DO
Diskette drive
n
failure
Drive
n does not work or is not properly connected.
(
n is 0 or 1. Drives 0 and 1 refer to drives A and B.)
Check that drive
n is securely connected and power
is on.
Press
F1
to start Auto Setup to check the diskette
drive parameters.
If there’s still a problem, drive
n might need repair.
Diskette read failure –
press
F1
to run Auto
Setup. Press any other
key to retry boot
Remove the diskette from drive A and press
F1
to
start the system from the hard disk.
Or, insert a bootable disk in drive A and press
F1
.
Non-system disk or
disk error; Replace
and press any key
when ready
Remove the diskette from drive A and press any
key to start the system from the hard disk.
Or, insert a bootable disk in drive A and press
any key.
No boot device
available – press
F1
to run Auto Setup
Press
F1
to start Auto Setup. Change the hard
disk type to the correct setting. Exit and save
Auto Setup.
Summary of Contents for VERSA P
