NEC Versa Quick Start Guide - Page 17
Trouble Shooting Guide
E
ngl
ish
✔
LCD screen is dark and blank.
☞
Power saving mode has shut off the backlight. Press a keyboard key.
The built-in LCD may not be selected. Press Fn-F3 once or twice to select the
LCD video mode.
Screen brightness or contrast needs adjustment. Use the Fn-F8 or Fn-F9 arrow
keys.
The system entered either Standby or Hibernation mode due to low battery
power. Plug in the AC adapter or replace the battery pack, and then press or slide
the power button to resume operation.
✔
Battery power does not last long.
☞
Use power-saving modes.
Fully discharge and charge the battery one time to recondition it.
Replace the battery.
✔
Information on the LCD is difficult to see.
☞
Adjust the brightness control. Use the Fn-F8 or Fn-F9 arrow keys.
✔
The power button does not resume the system.
☞
If the system does not resume, it may have automatically entered either Standby or
Hibernation mode due to low battery power. Attach the AC adapter and try again.
✔
The system does not automatically enter Standby mode.
☞
A disk drive might be busy. Wait until the disk drive stops and try again.
Problems at System Startup
The system displays an invalid configuration error message at power on when there are
the following conditions:
➤
The current configuration information doesn’t match configuration information
stored in Auto Setup, such as when an internal option is added.
➤
The system loses configuration information.
If either condition is true, the system displays an “invalid configuration information”
message.
To continue start-up procedures, press F2 (or F1 when prompted) and run the Setup
utility to set current system parameters.
If an error message appears before the operating system starts, note the message and
look up the error message in the section “Start Up Problems” in the electronic User’s
Guide.
N22_01_QSG.book Page 17 Thursday, November 14, 2002 10:22 AM
