System Board Settings B-5
1.
Turn off and unplug the system and any external options.
2.
Remove the system unit side panel (see “Removing the Side Panel” in Section 3).
3.
Locate the jumper bank on the system board (see Figure B-1).
4.
Move the jumper to the position shown in the following figure.
A
B
C
DOWN
G
H
I
UP
D
E
F
Reset CMOS settings
to default CMOS RAM
values.
Figure B-6 Clear CMOS Setting
5.
Turn on power and allow the system to boot.
6.
Turn off power.
7.
Move the jumper back to the default position shown in the following figure to
restore normal operation.
A
B
C
DOWN
G
H
I
UP
D
E
F
Normal mode
(Default)
Figure B-7 Normal CMOS Setting
8.
Replace the system cover and turn the power back on.
Setup Program Jumper
Use the following procedure to disable access to the Setup program in the BIOS.
1.
Turn off and unplug the system and any external options.
2.
Remove the system unit side panel (see “Removing the Side Panel” in Section 3).
3.
Locate the jumper bank on the system board (see Figure B-1).
Summary of Contents for POWERMATE PRO150
Page 152: ...A 16 Connector Pin Assignments ...
Page 160: ...B 8 System Board Settings ...
